Category Archives: Latest boat repair

We have moved into our new building at …. 12438 Hwy 707 Murrells Inlet SC 29576

We have a cold weather special going on right now ,  ONLY   $ 149.95  to winterize your inboard boat motor

25ft Baja , New transom ans stringers.

Baja 080Baja 078 Baja 075 Baja 077 Baja 076What a great job my fiberglass guys did.

Galley Maid Pumps

We removed Two Galley Maid pumps ,  both pumps did not work !!!   These pumps were sent to RAZ MARINE for a complete rebuild !!!  Cant wait to see what they look like when they come back to us.   Then we can get them back in the boat .victors baja 013 victors baja 020 victors baja 023

29 FT Rinker , New Transom assembly and new bravo three lower drive

We removed the outdrive , 5.7 engine and the bravo transom assembly.  We installed a new bravo transom assembly , installed the engine , split the outdrive in two ( upper & lower ).  We took the upper drive apart and cleaned all the old parts, inspected all the parts and rebuilt the upper drive, we then installed a new bravo three lower drive. added gearlube and test ran the boat.  Oh, sorry ….. forgot we had the props reworked too.wedding 2014 286wedding 2014 287wedding 2014 299victors baja 029 wedding 2014 309victors baja 030

5.0 Volvo High Pressure Fuel Pump & Tune Up

This high pressure pump is not cheep ……..lol    about  $900 just for the pump !!!!!      WOW !!!!!!
622013 323622013 326

26 FT Bayliner , New upper & Lower Outdrive

chaparral 2013 028chaparral 2013 029chaparral 2013 033chaparral 2013 040chaparral 2013 038

25 Ft Chaparral , New 7.4 MerCruiser Engine

This was a great FALL engine job ……… this 7.4 big block engine was under the rear deck !!!!!!
chaparral 2013 087

MerCruise 7.4 , rebuilt to a 496

This is a 7.4 , 454 big block.   Water ran down into carb and locked this engine up.   We removed it and had it rebuilt to a 496.   This engine went from 330 stock hp to 525 hp.   We did end up changing out the holley carb to a built webber.

Alpha 1 Gen 2 Gimbal Bearing Frozen

This is a alpha 1 gen 2 drive , gimbal bearing is frozen and it wont come out !  We tried to pull this bearing for about 45 min.  , we then went to drilling it and pulling it out in small pieces.  We then had to repair the upper shaft bearing because the upper nut was not tightened by the last boat repair shop !!!!

Fuel prices are down.

           Myrtle Beach fuel prices are down.   Lets all go boating !!!